How to install your new V2 AMG lip from TAKETWO.

Supplies required:

• Drill and 1.5mm drill bit
• Screwdriver
• Self tapping screws (included)
• Double sided tape (included)
• Measuring tape
• Isopropyl alcohol or similar cleaning solution

Step 1.

Wipe down lip and mounting surface with cleaning solution 

Step 2. 

Place double sided tape as below

Step 3.

With a friend, line up lip against front bumper, ensuring that the gap is even between the fins on each side and the bumper. Use a measuring tape or ruler to ensure perfect alignment. Press lip against front bar allowing the double sided tape to hold the lip in place.

Step 4.

Drill small pilot holes into the front bumper using the holes pre-drilled in the lip. WARNING only drill holes ~1-2mm deep. Drilling too deep can risk damage to the topside of the bumper.

Step 5. 

Using a screwdriver, install the supplied self tapping screws. Do not overtighten

Step 6.

Enjoy your new front lip!